On your iOS ® device, go to the device settings and select Wi-Fi ®. Select the SSID that your printer broadcasts (depending on the model, it may be Canon_ij_Setup or an SSID that has the model name in it, such as Canon_ij_053xx_MG6800series). Enter the password to connect to it if prompted. Learn more about the printer's default password. Re: Initial setup won’t accept password. The normal troubleshooting for 14.40 is to figure out if it is related to a 2.4ghz network setting (router) or if it password related. To determine if password related, try creating an "open" network on the 2.4 ghz band. Login to your router and disable the password for your SSID (network name). Unplug the power cable for 15 seconds. Reconnect the power cable and wait five seconds. Press the Power button again to restart your Mac. Step 3. Reset the administrator account using Terminal. It seems that macOS Big Sur stops accepting passwords when it forgets which users are administrators. If you don't know your Wi-Fi password or forget it, you can refer to the following steps to find or change it.. Device info in the label. For most models, the default SSID and password are in the label under the router, such as in the below picture. I assume you have a netgear router and a new/used laptop which should connect via W-LAN. Maybe your router has a network filter (allow disallow certain MAC-addresses). you can check this by accessing routerlogin.com and login. then go to advanced settings tab and wireless config. at the bottom there should be a button saying something like "Netgear Access Control". here, you can check if it is You can launch the Deco app, tap Network/More->Wi-Fi Settings page, and then turn off the 5G Wi-Fi network. 5. Connect your device to the guest network for a try. 6. Change the wireless security type on the Deco app. On the Deco app, you can tap Network/More>Wi-Fi Settings>tap Security to change the wireless security type. 7. TaraC. 700 286 54. Level 8. 07-30-2018 01:29 PM. No, as you noted, the Wi-Fi Direct password (the WPS PIN) expires after several minutes. You need to start the process over and generate a new PIN. The instructions to do that are in the document I linked to in my original post under "I want to obtain the WPS Pin to complete the Wi-Fi Direct setup". I went through the usual hoops, setting wifi to 2.4Ghz but I kept getting an “invalid password” message. Retried several times, reset the camera, reset the network. Still nothing worked. Working with Eero’s (amazing) tech support, they suggested I change my password. I removed the trailing special character and it worked AOK. Starting with Connectify Hotspot 2017 you can even add Emojis and Special Characters to your Hotspot Name! Press the ‘Start Hotspot’ button to share your Internet connection. Make sure you have the ad blocker option selected, to save bandwidth, money and battery life. Connect your devices. Any WiFi enabled devices can connect to your Hotspot! Follow the basic steps for connecting to a WiFi network. The device has not been blocked or paused in xFi. Learn all about xFi. The network password has not changed. The issue may be with your device. Try restarting it. This common Internet troubleshooting strategy can often resolve issues. Try troubleshooting the device from xFi. iwHjITJ.